RESUMO
Carbon nanotubes (CNTs) and graphene nanoplatelets (GNPs) with exceptional mechanical, thermal, chemical, and electrical properties are enticing reinforcements for fabricating lightweight, high-strength, and wear-resistant metal matrix composites with superior mechanical and tribological performance. Nickel-carbon nanotube composite (Ni-CNT) and nickel-graphene nanoplatelet composite (Ni-GNP) were fabricated via mechanical milling followed by the spark plasma sintering (SPS) technique. The Ni-CNT/GNP composites with varying reinforcement concentrations (0.5, 2, and 5 wt%) were ball milled for twelve hours to explore the effect of reinforcement concentration and its dispersion in the nickel microstructure. The effect of varying CNT/GNP concentration on the microhardness and the tribological behavior was investigated and compared with SPS processed monolithic nickel. Ball-on-disc tribological tests were performed to determine the effect of different structural morphologies of CNTs and GNPs on the wear performance and coefficient of friction of these composites. Experimental results indicate considerable grain refinement and improvement in the microhardness of these composites after the addition of CNTs/GNPs in the nickel matrix. In addition, the CNTs and GNPs were effective in forming a lubricant layer, enhancing the wear resistance and lowering the coefficient of friction during the sliding wear test, in contrast to the pure nickel counterpart. Pure nickel demonstrated the highest CoF of ~0.9, Ni-0.5CNT and Ni-0.5GNP exhibited a CoF of ~0.8, whereas the lowest CoF of ~0.2 was observed for Ni-2CNT and Ni-5GNP composites. It was also observed that the uncertainty of wear resistance and CoF in both the CNT/GNP-reinforced composites increased when loaded with higher reinforcement concentrations. The wear surface was analyzed using scanning electron microscopy (SEM) and energy dispersive spectroscopy (EDS) analysis to elucidate the wear mechanism in these composites.
RESUMO
Titanium carbide (TiC) reinforced nickel (Ni) matrix composites were processed via mechanical alloying (MA) followed by spark plasma sintering (SPS) process. Mechanical alloying has gained special attention as a powerful non-equilibrium process for fabricating amorphous and nanocrystalline materials, whereas spark plasma sintering (SPS) is a unique technique for processing dense and near net shape bulk alloys with homogenous microstructure. TiC reinforcement varied from 5 to 50 wt.% into nickel matrix to investigate its effect on the microstructure and mechanical behavior of Ni-TiC composites. All Ni-TiC composites powder was mechanically alloyed using planetary high energy ball mill with 400 rpm and ball to powder ratio (BPR) 15:1 for 24 h. Bulk Ni-TiC composites were then sintered via SPS process at 50 MPa pressure and 900-1200 °C temperature. All Ni-TiC composites exhibited higher microhardness and compressive strength than pure nickel due to the presence of homogeneously distributed TiC particles within the nickel matrix, matrix grain refinement, and excellent interfacial bonding between nickel and TiC reinforcement. There is an increase in Ni-TiC composites microhardness with an increase in TiC reinforcement from 5 to 50 wt.%, and it reaches the maximum value of 900 HV for Ni-50TiC composites.
